RAW MATERIALS

 

ANILINE LEATHER

Aniline Leather is Italian full grain calfskin leather aniline dyed with a deep lustre, and a glossy finish. m0851’s Aniline leather is produced by a highly qualified Italian tannery, established in 1967, with a “Gold Rated” environmental performance.

Aniline dye is a colorless, nontoxic water based liquid obtained from the organic synthesis of resins. The dye penetrates through the full grain leather, preserving its original surface with all natural markings and characteristics, leaving the rich feel of the leather intact. The gloss finish is achieved by ironing and then polishing the surface with transparent wax.

 

Aniline Leather in a few words:

- HANG TAG CODES: LAL (leather jackets), BAL (bags), AAL (accessories)
- Natural leather with little or no surface coating;
- Lightweight;
- Breathable;
- Soft, smooth, and buttery to the touch
- Delicate in its elegance, but resilient and durable.
- Used in  0.3mm 0.5mm and 0.7mm thicknesses for garments, bags and accessories.

 

A FEW FACTS AND RECOMMENDATIONS IN CARING FOR ANILINE LEATHER

- Wipe off any surface dirt with a soft damp cloth. Do not spot clean; wipe down the whole section stitch to stitch to avoid color variations and spotting.
- Regularly remove dust and dirt to prevent permanent stains. This will also revitalize and revive the color of the leather.
- Aniline leather has been deep-dyed for a rich, long-lasting color. Please be aware that these rich dyes may transfer onto light colored clothing if wet or humid or at the time of initial wear. To minimize the potential of color transfer, we recommend regular use of Tana Leather Protector #16.
- Note that red dyes do not set as well as other colors in Aniline, and therefore present a higher risk of color variation when wet or after the leather is wiped down. We recommend spraying with  Tana Leather Protector #16 before initial use and regularly as it is known to help set red dyes.
- Aniline leathers have barely any substance applied to their surface, which allows for the naturally soft and smooth hand of these fine leathers to be showcased. There is little barrier against spillage and staining. m0851’s water-based Leather Protector which will offer a shield from unwanted markings and spills.
- Use m0851 Leather Cleaner for deeper stains. Do not spot clean; wipe down the whole section stitch to stitch using a damp cloth and Leather Cleaner to avoid color variations and spotting.
- Always use the m0851 Leather Protector to recondition the leather after using the m0851 Leather Cleaner. Again, make sure to wipe down entire section stitch to stitch with a damp cloth and Leather Protector. Both products need to be used together, as the cleaner strips away some of the protective layer of the leather. Leather Protector reconditions it.
- Frequency depends on use. The more your leather good is exposed to wear and tear and the elements (rain, snow, dirt, body oils, etc.), the more it requires regular conditioning.
- Our aniline leather is water resistant, however, if exposed to heavy rain, the leather may become stiff. Lay your product flat to allow a full drying, then apply m0851 Leather Protector to restore the leather’s suppleness.

BLOOM LEATHER

Bloom Leather is an Italian full grain calfskin leather semi-aniline dyed with a deep lustre. Showcasing the natural pebbled finish of the leather, Bloom is light and has a supple handfeel.

The semi-aniline dye is water-based liquid obtained from the organic synthesis of resins. The slightly pigmented dye penetrates through the full grain leather, which results in a deep and rich color. It also serves as a protective barrier against stains and enhances its durability.

 

Bloom Leather in a few words:

- HANG TAG CODES: ABL (accessories), BBL (bags)

- Semi-aniline dye

- Naturally pebble finish

- Supple hand feel

- Resistant and durable leather

- Used in 16mm thickness for bag and accessories

 

A FEW FACTS AND RECOMMENDATIONS IN CARING FOR BLOOM LEATHER

 - Wipe off any surface dirt with a soft damp cloth. Do not spot clean; wipe down the whole section stitch to stitch to avoid color variations and spotting.

- Use m0851 water-based Leather Protector which will offer a shield from unwanted markings and spills and will also recondition the leather.

- Use m0851 Leather Cleaner for deeper stains. Do not spot clean; wipe down the whole section using a damp clean cloth with the cleaner on it.

- Always use m0851 Leather Protector to recondition the leather after using the m0851 Leather Cleaner. Both products need to be used together, as the cleaner strips away some of the protective layer of the leather. Again, make sure to wipe down entire section stitch.

- When exposed to heavy rain, the leather may become stiff. Wipe off water with a clean dry cloth and lay your product flat to allow a full drying. Once completely dry, apply m0851 Leather Protector to restore the leather’s suppleness.

- Tana Leather Protector Spray #16 or Moneysworth Best Spray Protector can be used on Bloom leather to protect it against stain and spillage.

  

 

 

 

RIMINI LEATHER

Rimini Leather is an Italian full grain calfskin that is semi-aniline dyed and has a soft mat finish.

The semi-aniline dye is water-based liquid obtained from the organic synthesis of resins. The slightly pigmented dye penetrates through the full grain leather, which results in a deep rich color. It also serves as a protective barrier against stains and enhances its durability.

 

RiminiLeather in a few words:

 

 

 

VACHETTA LEATHER

Vachetta leather is an Italian full grain bovine leather that has been vegetable tanned. This practice produces a leather with greater density, body and firmness while respecting the environment.

Once the tanning process is completed, the Vachetta hides are then milled and tumble-dried to obtain a leather that is softer, showing its characteristic pebbled finish. It is renowned for its durability and strength and will age beautifully with wear, acquiring a distinctive patina.

 

Vachetta Leather in a few words:

- HANG TAG CODES: AVR (accessories), BVR (bags)
- Vegetable tanned leather;
- Firm and structured;
- Pebbled textured;
- Strong and resistant, will aquire a beautiful patina with wear;
- Used in 18mm thicknesses for bags and accessories.
 

 

A FEW FACTS AND RECOMMENDATIONS IN CARING FOR VACHETTA LEATHER

- Wipe off any surface dirt with a soft damp cloth. Do not spot clean; wipe down the whole section stitch to stitch to avoid color variations and spotting.
- Regularly remove dust and dirt to prevent permanent stains. This will also revitalize and revive the color of the leather.
- Vachetta leather has been deep-dyed for a rich, long-lasting color. Please be aware that these rich dyes may transfer onto light colored clothing if wet or humid or at the time of initial wear. To minimize the potential of color transfer, we recommend use of Moneysworth Best protective spray.
- Vachetta leathers have barely any substance applied to their surface, which allows for the naturally soft and smooth hand of these fine leathers to be showcased. There is little barrier against spillage and staining. Moneysworth Best protective spray will help protect your Vachetta item.

 

 

 

VTA – TALMIGO 

M0851’s “Talmigo” cotton is a water-resistant fabric that acquires a beautiful leather-like patina with age and wear, produced in an Italian mill founded in 1893 whose talent lies in innovative textile finishing processes. At m0851, Talmigo has been a part of the collection for close to a decade.

 VTA – Talmigo in a few words:

- HANG TAG CODE: VTA, VCN, 
- 100% denim-base cotton twill with polyurethane resin coating
- Woven, dyed and finished in Italy
- A versatile, durable water-repellent material.
- Used in making outerwear for both men and women.

  

A FEW FACTS AND RECOMMENDATIONS IN CARING FOR VTA- TALMIGO

 Here are a few tips and tricks to maintain your Talmigo cotton garment’s external shell.

- Remove dust and dirt regularly using a soft, clean, damp cloth.
- For deeper stains, rub gently with a soft wet cloth and gently soap. Avoid abrasive soap and/or detergents.
- For lighter colored VTA-Talmigo cottons, some stains can simply be erased using a white pencil eraser.
- Before using any new cleaning agent on your garment, always test it out on a small section in a less visible area.
- Always follow instructions on the content label.
- Warning : When material becomes saturated with water, there is a chance color transfer may occur.

 

VTA-WOOL

M0851’s Fall VTA-Talmigo outerwear program includes styles for both men and women. The outer shell is made from m0851’s VTA-Talmigo cotton while the sleeves are lined with soft nylon. and filled for additional warmth, and the body in wool. Perfect for Fall in the city.

 

KEY INSTRUCTIONS

- Machine-wash cold water at permanent press;
- Do not bleach;
- Tumble Dry at low heat, permanent press setting;
- Iron at low temperature;
- Do not dry clean;

 

VTA – 4 SEASONS

M0851’s 4-season VTA-Talmigo outerwear program includes styles for both men and women. The outer shell is made from m0851’s VTA-Talmigo cotton and lined with soft nylon. Water and wind resistant, it is perfect for Spring, Fall or any tempered, humid climate.

 

KEY INSTRUCTIONS

- Machine-wash cold water at permanent press;
- Do not bleach;
- Tumble Dry at low heat, permanent press setting;
- Iron at low temperature;
- Do not dry clean.

 

VTA – PARKA

M0851’s VTA-Talmigo parkas includes styles for both men and women. The outer shell is made from m0851’s VTA-Talmigo cotton and lined with soft nylon. It is lined in Isosoft® filling – 200 grams per square inch in the body and 150g in the sleeves and hood for warmth and comfort during cold Winter months.

 

KEY INSTRUCTIONS

- Machine-wash cold water at permanent press;
- Do not bleach;
- Tumble Dry at low heat, permanent press setting;
- Iron at low temperature;
- Do not dry clean.

- Do not compress or flatten your insulated jacket for long periods of time. Compressing the jacket will cause the filling to condense and lose some of its insulating properties.

  

WHAT KIND OF LINING IS USED IN m0851’S VTA – TALMIGO 4-SEASON GARMENTS & PARKAS?

Content: 100% nylon fine gauge, highly resilient, lightweight microfiber.

 

 

 STORING YOUR M0851 PRODUCTS

- Remove any surface dust, dirt and moisture with a clean damp cloth.
- On leather where m0851 Conditioner is recommended, apply a light layer of leather conditioner to recondition the leather before storing (recommended once a year, if the garment is not being used). Wait at least 30 minutes to let the leather absorb the conditioner and dry.
- All your m0851 leather goods should be stored in the m0851 garment/dust bag provided at the time of purchase - in a place away from direct sunlight or harsh artificial light.
- Leather goods should be stored in a cool, dry place.  
- Do not store in a plastic bag/garment bag. Even a small amount of moisture can result in mildew or mold developing.
- Do not hang your bag by the straps or handles as this adds stress to the leather and could result in stretching or deforming.

- Hang your coat or piece of clothing on a hanger. Do not hang by the collar or upper back label. This could result in stretching or deforming. 

 

KEY CARE INSTRUCTIONS FOR M0851 LEATHER PRODUCTS

- Do not wash
- Do not dryclean
- Do not bleach
- Do not force dry; do not tumble dry
- Do not starch
- Do not iron
- Avoid harsh cleaners or abrasive soap or detergent or greasy substances such as alcohol, wax and mink oils; this will distress and clog the leather’s pores.

Europe

  • Canada
  • USA
  • --
  • Europe
  • Japan
  • Other

English

  • Français
  • English